September 2004
2-24 Programming Site Data
Selecting Mass Flow Units 1. Press [W] and [X] to select the desired mass flow units for the
flow rate display and press [ENTER]. The available units for this
prompt are determined by the selection made at SYSTEM UNITS on
the previous page.
2. Press [
W] and [X] to select the desired time units for the mass
flow rate display and press [ENTER].
3. Press [
W] and [X] to select the desired number of digits to the
right of the decimal point in the mass flow rate display and press
[ENTER].
4. Press [
W] and [X] to select the desired units for the totalized mass
flow rate display and press [ENTER]. The available units for this
prompt are determined by the selection made at SYSTEM UNITS on
the previous page.
5. Press [
W] and [X] to select the desired number of digits to the
right of the decimal point in the totalized mass flow rate display
and press [ENTER].
Procedure Options After completing the above steps, the meter returns to the Global
PROGRAM window. Do one of the following:
• You have completed entering “quick startup” data. You can
continue programming or exit the user program as described
below.
• To continue regular programming, refer to Appendix A, Menu
Maps, to navigate to the desired menu.
• To leave the user program, press [ESC] three times.
To Next Page
Loading...
