GE AquaTrans AT868 - Editing Meter Properties

PanaView™ for IDM-Compatible Meters (916-086B) F-7
September 2004
Editing Meter Properties Through PanaView™, you can edit the properties of your IDM-
compatible flowmeter. You can:
• Set the meter clock, or synchronize it with the PC clock
• Read, plot and save transducer signals
• Clear totalizers
• Save site files to the meter or PC
• Clear sites from the meter
• Print site files to the PC
To edit the properties of your IDM-compatible meter:
1. Highlight the meter (as shown in Figure F-6 on page F-6).
2. Open the "Edit" menu and select the "Properties" option, as
shown in Figure F-8 below.
Figure F-8: The Properties Option in the Edit Menu