GE B90 - Event Records

6-12 B90 LOW IMPEDANCE BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
RECORDS CHAPTER 6: ACTUAL VALUES
6
This menu displays the user-programmable fault report actual values. See the User-Programmable Fault Report section in
chapter 5 for information on this feature.
6.5.2 Event records
6.5.2.1 Enhanced and standard front panels
ACTUAL VALUES  RECORDS  EVENT RECORDS
The event records menu shows the contextual data associated with up to the last 1024 events, listed in chronological
order from most recent to oldest. When all 1024 event records have been filled, the oldest record is removed as a new
record is added. Each event record shows the event identifier/sequence number, cause, and date/time stamp associated
with the event trigger. See the
COMMANDS  CLEAR RECORDS menu for clearing event records.
Only major output operands generate events, not every operand. Elements that assert output per phase, for example, log
operating phase output only without asserting the common three-phase operand event.
See also the system log (syslog) information in the previous chapter.
The event records are also viewable in the software and in a web browser. The figure shows the event records in the
software. To view them in a web browser, enter the IP address of the device. When an oscillography icon displays, click it to
open it.
Figure 6-3: Event records viewed in EnerVista software

LAST REPORT DATE:
2002/10/09 08:25:27
 EVENT RECORDS


EVENT: XXX
XXX

Date and time stamps

EVENT: 3
POWER ON

EVENT 3
DATE: 2000/07/14

EVENT: 2
POWER OFF

EVENT 3
TIME: 14:53:00.03405

EVENT: 1
EVENTS CLEARED