GE B90 - Virtual Inputs; Clear Records; Set Date and Time

7-2 B90 LOW IMPEDANCE BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL
COMMANDS MENU CHAPTER 7: COMMANDS AND TARGETS
7
7.1.1 Virtual inputs
COMMANDS  VIRTUAL INPUTS
The states of up to 64 virtual inputs are changed here. The first line of the display indicates the ID of the virtual input. The
second line indicates the current or selected status of the virtual input. This status is a state off (logic 0) or on (logic 1).
7.1.2 Clear records
COMMANDS  CLEAR RECORDS
This menu contains commands for clearing historical data such as the event records. Data is cleared by changing a
command setting to “Yes” and pressing the
ENTER key. After clearing data, the command setting automatically reverts to
“No.”
7.1.3 Set date and time
COMMANDS  SET DATE AND TIME
The date and time can be entered on the front panel keypad. The time setting is based on the 24-hour clock. The complete
date, as a minimum, must be entered to allow execution of this command. The new time and date take effect when the
ENTER key is pressed.
The clock also can be synchronized to the local computer time among several UR devices. Use the Synchronize Devices
entry in the Online Window area of the EnerVista software. (Click the button at the top of the window that opens.)
When the relay is synchronizing to an external time source such as PTP, IRIG-B, or SNTP, the manually entered time or the
manually synchronized time is over-written.
The timescale of the entered time is local time, including daylight savings time where and when applicable.
 COMMANDS
 VIRTUAL INPUTS

Virt Ip 1
Off
Range: Off, On

Virt Ip 2
Off
Range: Off, On


Virt Ip 64
Off
Range: Off, On
 COMMANDS
 CLEAR RECORDS

CLEAR USER FAULT
REPORTS? No
Range: No, Yes

CLEAR EVENT RECORDS?
No
Range: No, Yes

CLEAR OSCILLOGRAPHY?
No
Range: No, Yes

CLEAR UNAUTHORIZED
ACCESS? No
Range: No, Yes

CLEAR DIRECT I/O
COUNTERS? No
Range: No, Yes.
Valid only for units with Direct Input/Output module.

CLEAR ALL RELAY
RECORDS? No
Range: No, Yes
 COMMANDS
 SET DATE AND TIME

SET DATE AND TIME:
2000/01/14 13:47:03
Range: YYYY/MM/DD HH:MM:SS