APPENDIX D: MISCELLANEOUS REVISION HISTORY
B90 LOW IMPEDANCE BUS DIFFERENTIAL SYSTEM – INSTRUCTION MANUAL D-3
D
Table D-4: Major changes for B90 manual version AE1 (English)
Table D-5: Major changes for B90 manual version AC1 (English)
Page Description
--- General revision
--- Added routable GOOSE content in chapters 2 and 5
3-34 Updated RS422 and Fiber Interface Connection figure for the clock channels (from 7a and 7b to 1a and 1b)
4- Added Engineer content
5- Updated IEC 61850 content
A- Updated FlexAnalog table for most UR products
Page Description
--- General revision. Added online help and updated generic online help.
--- Deleted EAC logo from title page and deleted EAC certification from Approvals specifications because document not
translated into Russian
--- Updated number of Direct Inputs / Direct Outputs, increasing them from 96 to 256, in specifications, FlexLogic operands table,
settings, actual values, Modbus memory map
2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines
4-28 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter
5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port
5-47 Updated IEC 61850 section
5-58 Added Support for Routable GOOSE section
5-143 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section
10-1 Added Monitoring section
10-2 Added Retrieve Files section
C- Added Command Line Interface appendix