GE DigitalFlow GF868 - Initial Setup Data

Appendix B. Data Records
94 DigitalFlow™ GF868 Programming Manual (1-Channel)
B.2 Initial Setup Data
After the Model GF868 flowmeter has been installed, some initial setup data must be entered using the User Program,
prior to operation. Record that information in Table 21.
Table 21: Initial Setup Data
General Information
Model # Reference
Software Vers. Date
Serial # Z Dimension
Measurement Method - ACTIV
Site Status Burst Measure Mode Skan S/M
System Parameters - SYSTEM
Site Label Vol. Dec. Digits
Site Message Totalizer Units
System Units English Metric Tot. Dec. Digits
Pressure Units Mass Flow
Gage Pressure Mass Flow Time
Stopwatch Total. Auto Manual MDOT Dec. Dig.
Vol. Units Mass (TOT.)
Vol. Time Units Mass Dec. Dig.
Pipe/Transducer Parameters - PIPE
Trans. # Reynolds Corr. Off On
Spec. Trans. Hz Kin. Visc.
Spec. Trans. Tw Multi K Factors
Pipe O.D. Edit Table
Pipe Wall Cal. Factor
Path Length (P) Error Handling
Axial Length (L) Baud Rate
UART Bits
K Factor Table
K-Factor # Velocity K-Factor K Factor # Velocity K-Factor
111
212
313
414
515
616
717
818
919
10 20