GE DigitalFlow GF868 - Setting up the Analog Inputs

Chapter 1. Programming Site Data
18 DigitalFlow™ GF868 Programming Manual (1-Channel)
1.9.5 Setting up the Analog Inputs
1. Press [F1] to set up input A or [F2] to set up input B.
Note: The set up of input A is used as an example in this manual. Identical procedures would be used to set up input
B. (An analog input option card may contain one standard analog input and one RTD analog input.)
2. Enter a Label of up to eight characters for input A and press [ENT].
3. At the Input Measurement prompt, press [F1] = OFF to disable input A and return to the previous prompt, or press
[F2] = PRESR (pressure), [F3]= TEMP (temperature) or [F4] = SPEC (special) to designate the input.
4. Do one of the following:
• If you selected PRESR or TEMP, proceed to step 5.
• If you selected SPEC, complete the steps below.
a. Enter an Input Name and press
[ENT].
b. Enter the Input Units of measurement and press [ENT].
5. Enter the Zero Value for the low end of the chosen input range and press [ENT].
6. Enter the Full Scale Value for the high end of the chosen input range and press [ENT].
7. Press [F1]-[F2] to set up another input or press [EXIT] to select another slot for setup.
For instructions on setting up additional inputs and/or outputs proceed to the appropriate section. Otherwise, press
[EXIT] to return to the main I/O menu prompt.