GE DigitalFlow GF868 - C.5.3 Plotting Transducer Signals; D.3 Selecting the Desired Measurements

DigitalFlow™ GF868 Programming Manual (1-Channel) 105
Appendix C. Programming with PanaView
C.5.3 Plotting Transducer Signals
To plot the selected signal, click on Plot. A graphical window opens, as shown in Figure 28.
Figure 28: Signal Graph Window
C.5.4 Saving Transducer Signals
To save the raw signal, click Save. A window opens similar to Figure 29. Enter the desired name, and click Save to save
the signal as a text file.
Figure 29: Save As Window
C.5.5 Clearing Totalizers
To clear the meter totalizers, click on the Clear Totalizers button in the Properties window. The meter totalizers are
reset to 0.