GE DigitalFlow GF868 - C.5 Editing Meter Properties

DigitalFlow™ GF868 Programming Manual (1-Channel) 101
Appendix C. Programming with PanaView
C.5 Editing Meter Properties
Through PanaView, you can edit the properties of your GF868. You can:
• Set the meter clock, or synchronize it with the PC clock
• Read, plot and save transducer signals
• Clear totalizers
• Save site files to the meter or PC
• Clear sites from the meter
• Print site files to the PC
To edit the properties of your GF868:
1. Highlight the meter (as shown in Figure 22 on page 100).
2. Open the “Edit” menu and select the “Properties” option, as shown in Figure 24.
Figure 24: The Properties Option in the Edit Menu