Appendix C. Programming with PanaView
100 DigitalFlow™ GF868 Programming Manual (1-Channel)
C.4 Adding the GF868 (cont.)
IMPORTANT: The Network ID number must match the Network ID programmed in the meter’s Communications menu.
If the initialization is successful, the Meter Browser shows a listing similar to Figure 22.
Figure 22: The Updated Network Tree
Note: The model number and version that appear will vary with your particular meter and software version.
However, if the settings do not match, or there is some other difficulty, a screen appears similar to Figure 23.
Figure 23: Communication Error Screen
The screen offers the options of trying again or of canceling the operation. Click on the desired choice, and then on
[OK]
to confirm the choice or on [Exit Application] to close PanaView.
Note: If you cannot resolve the problem, contact the factory for help.
To Next Page
Loading...
