Introduction
© 2015 General Electric Company – All rights reserved. ADTS 405 Mk2 Instruction Manual-English | 89
6.2.49 SETUP, EXECUTE TEST PROGRAM
This function sets up the results file options.
Result data generated by the test program can either be sent out to the printer port or saved to a
result file and stored in the ADTS 405. Pressing F1, the [PRINT/SAVE] key, sets the option. Any of the
results files, stored in the ADTS 405, can be sent to the printer port. Press F2, the [PRINT FILE] key,
to select the required file.
6.2.50 SETUP, HELP
This function provides help on the set-up key.
6.2.51 SETUP, or (Nudge keys)
This function allows the increment value of the nudge key to be adjusted for every parameter.
1. When SETUP, orare pressed, the display shows the value of nudge for the parameter
last displayed.
2. Enter a new value to replace the present value.
3. Use [NEXT] or [PREV] to display other parameters.
4. Press CLEAR/QUIT when the nudge values of all the required parameters have been
changed.
In aeronautical units, the parameters available are:
In pressure units, the parameters available are:
5. The nudge value can be used for large increments e.g., 100 kts or 5000 ft to “step through”
the cardinal points of a test.
CAUTION Make sure the nudge increment is set to a suitable value before using the
nudge facility to change the aim value.
6.2.52 MINIMUM SETUP
Minimum set-up allows access to a limited number of set-up functions. Any parameter changed
under set-up returns to the default settings at power-down. The CONFIGuration mode may be used
to change the default settings so that the ADTS 405 powers-up in the required state.
6.2.53 SETUP, [UNITS], [AERO]
The current operating limits are changed to the default aeronautical units. These units can be
programmed using CONFIG, [UNITS], [AERO].
6.2.54 SETUP, [UNITS], [PRESS]
The current operating limits are changed to the default pressure units. These units can be
programmed using CONFIG, [UNITS], [PRESS].
ALT CAS/TAS MACH ROC RATE CAS
Ps Pt Qc EPR
RATE Ps - RATE Qc RATE EPR
To Next Page
Loading...
Need help?
General
