Chapter 3. OPERATION
16 | ADTS 405 Mk2 Instruction Manual-English © 2015 General Electric Company – All rights reserved.
3.2.2 Power-up
a. Check the power indicator is illuminated and set the front panel power switch to
OPERATE.
b. The display will show the following sequence:
1. Power-up screen.
2. ADTS 405 power-up screen.
3. Date of the last calibration and type of main transducer fitted.
4. Self-test message.
5. Measuring ground pressure message.
6. Equalizing system pressures message.
7. Display shows Leak Measure mode and the number of parameters last selected in
configuration.
i. The display, on the front panel or
hand-terminal, shows:
Note: V.xx will display the current software version number.
ii. After a short time the display
shows:
iii. Date format can be set to a leading value of day or month in SETUP.
DK425 V.xx
Display Power Up
Please Wait
DRUCK
ADTS 405
DK415
VER.xx
Last Calibration
dd/mm/yy (dmy)
RPT Transducer
PLEASE WAIT
SYSTEM STATUS
RED - FAULT
SYSTEM STATUS
ORANGE - NOT READY
To Next Page
Loading...
Need help?
General
