GEK-113000AE F650 Digital Bay Controller 5-9
5 BOOTCODE AND FIRMWARE UPGRADE 5.1 UPGRADE FROM VERSION BELOW V7.00.
5
Figure 5–16: UPDATE CONFIRM
18. If click “YES” ("Sí" in the figure) the process will start, beginning with the relay flash memory deletion, so at this point
all the information stored in the relay will be lost. Until now, no important change has been made to the relay, the boot
memory upgrading process has just been prepared.
The process of flash memory erasing and boot code downloading can take some minutes, during which a progress bar
is displayed.
Figure 5–17: FLASH MEMORY ERASE PROGRESS BAR
19. If the process is successful, continue with step 20 hereafter. If not and the relay gets stuck during at “Sending file
imagen_kernel…” (see figure below)
Figure 5–18: DOWNLOAD PROCESS ADVISORY
To Next Page
Loading...
