5-28 F650 Digital Bay Controller GEK-113000AE
5.2 FIRMWARE UPGRADE VERSION V7.00 OR HIGHER 5 BOOTCODE AND FIRMWARE UPGRADE
5
5- Once the password is obtained enter in the above window and the following messages will appear if the password
is correct.
Figure 5–46: EXECUTED SUCCESFULLY
6- After the successful operation, the “SEND” button will be disabled. It is not allowed to make another change from
here, so it can be seen what changes have been made. The new order code will appear on the status bar.
Figure 5–47: NEW ORDER CODE
To Next Page
Loading...
