GE ImageQuant LAS 4000 - Performing an Exposure; Workflow

4
Open the IDX door and insert the tray. Place the Epi or Trans trays in position with the side with a
hole facing outwards.
5
Ensure the lens cap is removed and close the IDX door.
4.3 Performing an exposure
This section describes the steps for exposing a sample and saving the image. In this description the
screen images shown are for exposure of an ethidium bromide (EtBr) stained sample. The general
procedure is however similar for all types of sample. For detailed instructions refer to the ImageQuant
LAS 4000 User Manual.
Images may also be obtained by repeated, incremental or programmed exposure of a sample. For
detailed instructions on these types of exposure, refer to the ImageQuant LAS 4000 User Manual.
4.3.1 Workflow
The workflow for exposing a sample and recording an image is as follows:
52 Getting Started with ImageQuant LAS 4000 28-9607-59 AB
4 Operation
4.2 Preparation
4.2.3 Placing the sample