GE ImageQuant LAS 4000 - 4.5 Exposing chemiluminescent samples

8
Remove the lens cap.
Lens cap
9
Install the lens hood.
Lens hood
3.5.4 Attaching a filter to the filter changer
This section describes how to attach a filter to the filter changer, and how to register the filter at the
chosen filter changer position in the ImageQuant LAS 4000 Control Software.
Note:
Before installing or changing filters in the filter changer, the ImageQuant LAS 4000 Control
Software should be installed and running. For instructions on installing the software,
refer to Section 3.4 Installation of the software, on page 27.
Getting Started with ImageQuant LAS 4000 28-9607-59 AB 37
3 Installation
3.5 Installation of hardware
3.5.3 Installing the lens