GE ImageQuant LAS 4000 - Connecting the Camera Head to the Computer; Installing the Lens

3.5.2 Connecting the camera head to the computer
Connect the USB cable from the USB connector of the ImageQuant LAS 4000 camera head to one of
the USB ports of the computer.
Analysis PC (Optional) Instrument
Note:
•
Use the USB cable supplied with the equipment.
•
Do not connect via a USB hub.
•
Do not use other USB equipment on the PC while ImageQuant LAS 4000 is in use.
This may result in the loss of image data.
3.5.3 Installing the lens
This section describes how to install the LAS High Sens. lens. For instructions on installing the wide
view lens, refer to the ImageQuant LAS 4000 User Manual.
1
Ensure that the ImageQuant LAS 4000 and the PC are connected. Turn on the instrument and the
PC and start the ImageQuant LAS 4000 Control Software.
2
Select Lens Exchange... in the Option menu.
A message is displayed.
Click OK.
Getting Started with ImageQuant LAS 4000 28-9607-59 AB 35
3 Installation
3.5 Installation of hardware
3.5.2 Connecting the camera head to the computer