GE ImageQuant LAS 4000 - 6 Troubleshooting

6 Troubleshooting
This chapter describes various problems that can foreseeably occur with the ImageQuant LAS 4000
and ImageQuant LAS 4000 Control Software. Suggestions of possible countermeasures are given.
Take the following procedures if an error occurs:
1
Take note of the error code and error message on the monitor.
2
Turn off the power to ImageQuant LAS 4000 and the analysis PC, then turn them on again after
about ten seconds.
3
If the error persists, fill in the necessary items and the error code in the Service report fax sheet at
the end of the ImageQuant LAS 4000 User Manual, and then contact your GE Healthcare
representative.
64 Getting Started with ImageQuant LAS 4000 28-9607-59 AB
6 Troubleshooting