GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 7 Diagnostics/Troubleshooting 7 - 83
7-5-12 Diagnostics - BEP Interactive Tests - R4.x and later
Interactive tests in R4 and later have been reduced. Tests that are not supported are no longer listed.
If you want to run these tests, it is recommended to run on a DOS prompt instead of CDS. This test will
take approximately 70 seconds.
• Insert the service ky
• Exit from the scanner software and exit to Windows
• Start a DOS prompt
• Insert a blank DVD-R into the drive
• Enter the command:
cd %insite_home%\PCDoctor\bin
pcd run --file scripts\dvdminusr.xml
There is another test with a CD-R disk. It is not recommended because it takes over 30 minutes. If you
want to run the CD-R test, enter the command:
pcd run --file scripts\cdr.xml-R
Table 7-2 BEP Interactive Test Description Table - R4.x
Test Description
AVI playback
Tests playing back an AVI file.
CD-R test
Tests writing and reading to a CDR
DVD-R
Tests writing and reading data to a DVD-R disk
DVD READONLY
Not supported - DVD RAM read and write test
Keyboard
N/A
Microphone
N/A
Monitor
Monitor test patterns
Trackball
N/A
Sound
Generates sounds for testing the speakers
USB Ports
Lists USB Devices
To Next Page
Loading...
