GE LOGIQ E9 Service Manual

GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 1 Introduction 1 - 11
“PINCH POINT”
Indicates moving parts that may cause
injury (such as the top, rear of the LCD
Arm or XYZ Mech).
Various
“Mains ON”
Indicates the Power ON position of the
mains power switch.
“ON” Indicates the power on position of
the power switch.
CAUTION
THE ON/OFF BUTTON ON
THE OPERATOR PANEL
DOES NOT ISOLATE MAINS
SUPPLY
Rear of console
ON/OFF button
CAUTION
SYSTEM SHUTDOWN USING
THE ON/OFF BUTTON DOES
NOT DISCONNECT LOGIQ E9
FROM MAINS VOLTAGE.
For disconnecting LOGIQ E9 from
mains voltage after system shutdown,
please set the circuit breaker close to
the mains inlet to OFF as described in
4-2-3 "Power shut down" on page 4-7.
Operating Panel
“Protective Earth”
Indicates the protective earth
(grounding) terminal.
Used several places inside the system.
“Equipotential”
Indicates the terminal to be used for
connecting equipotential conductors
when interconnecting (grounding) with
other equipment as described in
IEC60601-1.
Rear of console
Alternating Current symbol is in
accordance with IEC 60878-01-14.
Rear Panel, Rating Plate, Circuit
breaker label of console and Front
Panel (if applicable).
Table 1-6 Product icons (Continued) 4 of 7
LABEL/SYMBOL PURPOSE/MEANING LOCATION
or

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor