GE LOGIQ E9 Service Manual

GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
8 - 220 Section 8-9 - BEP (Back End Processor) parts replacement
8-9-4-2 BEP I/O Board installation
Table 8-132 BEP I/O Board installation
Steps Corresponding Graphic
1.
Guide the I/O Board into the BEP frame.
2.
Be sure the three tabs on the end of the I/O
fit into the three slots in the back of the BEP
frame.
You will need to press in on the right side of
the I/O cover while pulling out on the left
side of the cover.
You may need to seat the lower tab first
and work up to the top
2.
Loosely insert all five screws before tightening them.
3.
Re-install the cables in the reverse order from when they were removed, following the markings
and re-install the Option Dongle.
4.
Re-install the HDD.
5.
Reconnect the I/O cabling.
6.
Connect the Battery cable to J3 on the EPS.
7.
Make sure all cables are clear of the BEP Cover and tilt the top of the BEP cover toward the BEP.
NOTICE
Be careful not to pinch any of the cables when installing the BEP cover.
8.
Tighten and secure the thumb screw(s) at the top of the BEP cover that attach the cover to the
BEP.
9.
Replace the side cover.
10.
Perform Functional Checks. See: 8-9-5-3 - Calibration and adjustments,
8-9-5-4 - Verification and 8-9-5-5 "Functional Checks" on page 8-225.

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor