GE LOGIQ E9 Service Manual

GE
D
IRECTION 5535208-100, REV. 2 LOGIQ E9 SERVICE MANUAL
Chapter 3 LOGIQ E9 Setup 3 - 31
3-6-9 Complete power down (cont’d)
3-6-9-1 Sleep Mode
Only available in LOGIQ E9 running R2.x.x and R3.x.x software.
Use Sleep Mode when you do a portable exam in order to reduce the time to start up the system. When
you use Sleep Mode, it only takes 90 seconds to start up the system versus 2-3 minutes. To activate
Sleep Mode, press the ON/OFF button and select Sleep.
Before returning a system to the customer, perform the functional checks. See: Section 4-3 "Functional
checks" on page 4-31.
NOTICE
For optimum system operation, it is recommended that a full shutdown of the system is performed at
least once every 24-hour period. If you shut down the system at the end of the day, no other action is
needed.

GE LOGIQ E9 Specifications

General

Type	Ultrasound System
3D/4D Imaging	Yes
Transducer Ports	4 active ports
Connectivity	DICOM, USB, Ethernet
Applications	Abdominal, Vascular, Musculoskeletal, Small Parts, Urology, Pediatric, Cardiac, Obstetrics/Gynecology
Transducers	Linear, Convex, Phased Array, Volume
Doppler Modes	Color Doppler, Power Doppler, Pulsed Wave Doppler, Continuous Wave Doppler
Elastography	Yes
Advanced Features	B-Flow, Volume Navigation
Portability	Cart-based system
Display	19-inch high-resolution LCD monitor