EasyManuals Logo

GE LOGIQ S8 User Manual

GE LOGIQ S8
418 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #190 background imageLoading...
Page #190 background image
GE HEALTHCARE PROPRIETARY TO GE
D
IRECTION 5394227, 12 LOGIQ S8/LOGIQ E8 SERVICE MANUAL
4 - 14 Section 4-3 - General procedures
4-3-8-1 Before moving the system (cont’d)
1.) Adjust the monitor and control panel using Up/Down control and Swivel control to their centered and
lowest positions. Refer to 4-3-6-1 To raise/lower the operator panel and 4-3-6-2 To move the
operator panel from side to side.
2.) Flip down the monitor and lock the monitor arm.
Figure 4-11 Flip down the monitor and lock the monitor arm
Figure 4-12 Moving/Transporting position
3.) Turn the system off, including the circuit breaker (see Section 3-7 "Power On/Off" on page 3-17),
and remove the plug from the wall.
4.) All cables from off-board peripheral devices must be disconnected from the console.
5.) Disconnect the footswitch from the console.
6.) Wind the power cable around the cable hook.
NOTE: To prevent damage to the Power Cord, DO NOT pull excessively on the cord or make sharp
bends while wrapping.
7.) Connect all probes to be used while off site. Ensure that probe cables are out of the way from the
wheels and not protruding beyond the console. Use the probe management hooks located below
the Operator Panel to further secure the probe cables.
8.) Store all other probes in their original cases or in soft cloth or foam to prevent damage.
9.) Put the coupling gel in the gel holder.
10.)Ensure that no loose items are left on the console and unlock the wheels.

Table of Contents

Other manuals for GE LOGIQ S8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the GE LOGIQ S8 and is the answer not in the manual?

GE LOGIQ S8 Specifications

General IconGeneral
TypeUltrasound System
Display TypeLCD
3D/4D ImagingYes
ConnectivityDICOM, USB, Ethernet
Display Size19 inches
TransducersLinear, Convex, Phased Array
Doppler ModesColor Doppler, Power Doppler, Spectral Doppler
Operating ModesB-Mode, M-Mode
ApplicationsAbdominal, Cardiac, Obstetrics, Gynecology, Vascular, Musculoskeletal
PortabilityCart-based
Transducer Ports4

Related product manuals