D-4 M60 MOTOR PROTECTION SYSTEM – INSTRUCTION MANUAL
REVISION HISTORY APPENDIX D: MISCELLANEOUS
D
Table D-5: Major changes for M60 manual version AC1 (English)
Page Description
--- General revision. Added online help and update generic online help.
--- Deleted EAC logo from title page and deleted EAC certification from Approvals specifications because document not
translated into Russian
--- Added Breaker Arcing Current content to product description, specifications, FlexLogic operands table, settings, FlexElement
tables, actual values, FlexAnalog table, features per product table, Modbus memory map, IMD table
--- Added Phase Time Overcurrent content to product description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Added Neutral Time Overcurrent content to product description, specifications, FlexLogic operands table, settings, features
per product table, Modbus memory map, IMD table
--- Added Breaker Restrike content to product description, specifications, FlexLogic operands table, settings, features per
product table, Modbus memory map, IMD table
--- Updated Disconnect (Breaker) Switch number from 16 to 8 in FlexLogic operands table, settings, features per product table,
Modbus memory map
--- Updated Ground Instantaneous Overcurrent number from 8 to 6 in FlexLogic operands table, settings, features per product
table, Modbus memory map
--- Update Neutral Instantaneous Overcurrent number from 8 to 4 in FlexLogic operands table, settings, features per product
table, Modbus memory map
--- Updated number of Phase Instantaneous Overcurrent elements in FlexLogic operands table, settings, features per product
table, Modbus memory map
2- Updated several specifications, such as TOC, IOC, number of FlexLogic lines
4-30 Added FlexLogic Design and Monitoring using Engineer section to end of Interfaces chapter
5-38 Added PRT FUNCTION settings in Network section to enable/disable each Ethernet port
5-50 Updated IEC 61850 section
5-61 Added Support for Routable GOOSE section
5-171 Updated number of FlexLogic lines from 512 to 1024 in FlexLogic Equation Editor settings section
5-200 Updated Figure 5-104 Thermal Model Logic diagram as per specification
9-1 Added Monitoring section
9-2 Added Retrieve Files section
C- Added Command Line Interface appendix
To Next Page
Loading...
