Product Overview
Icon Status Description
WLAN Connected The device is connected to an access point and is in the
process of obtaining an IP address.
If this icon is blinking, the device is acquiring an IP
address from DHCP.
WLAN Disconnected The device is not connected to a WLAN.
For more information about wireless certificate errors, see Wireless Network
Connectivity Errors on page 128.
3. Close the Network Status window by selecting something on the screen outside
of the window.
Changing the Brightness of the Screen
Perform one of the following steps to change the brightness level of the screen
from 10% to 100%:
NOTE:
The specified keys combination works only for English keyboard.
• To increase the brightness of the screen, select Alt + Arrow up keys on the
keyboard.
• To decrease the brightness of the screen, select Alt + Arrow down keys on the
keyboard.
Continue to select the keys to reach the desired level of brightness.
Table 6: Brightness Level
Condition When the device is powered
by A/C Power
When the device is powered
by the battery
Brightness level on initial
power up
80% 50%
Brightness level when you
change the power source
when the device is on
Resets to the saved
brightness value when the
device was last used on AC
Power.
Resets to the saved
brightness value when the
device was last used on the
battery.
The changes you make are automatically saved to your device and will not
change when you turn the device on or off.
2088531-370-2 MAC VU360
™
Resting ECG Analysis System 19
To Next Page
Loading...
Need help?
General
