GE MAC VU360

Patient Information
Table 11: Patient Information Screen
Item Field Description
1 Patient
Information
bar
Shows patient information, such as patient first name, last name, gender,
age, and other configured information.
2 Save button Select Save to save the patient information.
3 Collapse
button
Select the Collapse button or select a spont on the Patient Information
screen to collapse and show only the bar. Collapsing the screen saves the
entered information.
4 Search icon Use the keyboard to enter the Patient ID or Visit Number on the screen and
press Search icon on the respective field.
You can also swipe your finger in the upward or downward direction on the screen
to scroll through the screen. For information on updating data in the Patient
Information screen, see Enter Patient Information on page 32.
Start a Test for a New Patient
Start a test for a new patient in the Acquisition screen.
1. Select the Start New Patient icon located in the upper right corner of the
Acquisition screen:
If Then
A patient test is open with unsaved data, a
message tells that unsaved patient data will
be lost.
Select one:
• Select Start New Patient, all unsaved
patient data is deleted and new patient
data can be entered.
• Select Continue with Same Patient, the
data on screen is used.
Electrodes are put on a patient and then
removed or disconnected, the LED sensors
time out after 30 seconds. When the
electrodes are put on a patient again, the LED
sensors identify a patient. A message opens:
A new patient is identified.
Select one:
• No if you put electrodes on the same
patient and will start a test for that
patient.
• Yes if you put electrodes on a new patient
and will start a test.
2. If there are pending print tasks in the queue, a message opens that tells pending
print tasks will be deleted from the queue.
• Select Continue to delete pending print tasks and start the test for the new
patient. The Patient Information screen expands.
2088531-370-2  MAC VU360
™
Resting ECG Analysis System 31