PROFINET Controller has
detected a duplicate IP
Address on the network.
The location associated
with the fault will indicate
whether the duplication is
with the PROFINET
Controller itself, or with a
configured PROFINET
Device.
Either remove the device on the
network that has the duplicate IP
Address, or assign a new IP Address
to either the PROFINET Controller or
the conflicting device.
Note: The Fault Extra Data displays
the MAC addresses of the conflicting
devices in the MAC 1 field (bytes 8–
13) and the MAC 2 field (bytes 14–19).
If the PROFINET Controller is one of
the devices with a conflicting IP
Address, MAC 1 will be 0. This data is
stored in Big Endian (most significant
byte in lowest address) format.
Also, if the conflict is between
PROFINET devices on the network,
the DCP Tool can be used to help find
the conflict. Sorting by IP Address
within the tool may make it easier to
identify the duplicates.
PROFINET Controller has
detected that a previously
duplicated IP Address
conflict has been resolved.
The location associated
with the fault will indicate
whether the duplication
was with the PROFINET
Controller itself, or with a
configured PROFINET
Device.
To Next Page
Loading...
