Logging Data 7-9
August 2003
Setting up a New Log (cont.)
Figure 7-7: The Select Measurement Window
2. Scroll to the desired output type.
3. Press
[SEL] to confirm your selection.
4. The prompt then moves to a list of unit types. (The available
units depend on the selection made at the Data Source
prompt.) Scroll to the desired output unit.
5. Press
[F3] (OK) to confirm your selection.
6. You can repeat this procedure for up to 12 different
parameters.
7. When you have finished, press
[F2] (Cancel) to cancel the
entries, or
[F3] (Activate) to confirm the entries and start the
log.
If you started the log from the New Log option, the PM880
returns to Operate Mode, with a Pencil icon in the System Tray; if
you started it from within the Log Manager, the meter returns to
the Log Manager.
Select Measurement
No Unit Cancel OK
Hygro
Temperature
Pressure
Battery
UserFunction
Dew Point/°C
Dew Point/°F
Dew Point/K
Rel. Humidity
ppMv
ppBv
ppMw
MMSCF/IG
MMSCF/NG
To Next Page
Loading...
