GE PM880 - Entering the Service Menu

August 2003
8-2 Servicing the PM880
Entering the Service Menu
To enter the Service Menu, press the [MENU] key at the lower
right of the PM880 keypad. The Menu Bar replaces the Status
Bar at the top of the screen. Press the [
X] arrow key four times to
scroll from the Site Menu to the Service Menu. At the Service
Menu, press
[ENTER]. The screen appears similar to Figure 8-1
below. When programming, refer to Figure B-6 on page B-6 of
Appendix B, Menu Maps.
Figure 8-1: The Service Menu
To scroll to a particular option, press the [
T] or [S] arrow keys
until you reach the option. Then press
[ENTER] to open the option
window.
When entering parameters in an option, press:
• The [T] key to step through the available parameters.
• The [S] key to scroll back to a previously entered parameter.
• The [F2] key (Cancel) or the [ESC] key to exit an option at any
time and return to Operate Mode without changing the
parameters.
Signal, dB
32
Site Program Meter Logging Service
Units
Reports
Test
References
Test
X
Factory Defaults
Flash Update
Dew Point, °C
-52.0
Pressure, PSIg
55.00
Run Time, Hours
06
12
MIS Probe
Factory Calibration
Security Settings
About