Displaying and Configuring Data 5-7
August 2003
The Measurement Option
On occasion, you might need to change the actual parameter
measured in a given window.The Measurement option enables
you to reconfigure the window with one of five categories of data
source (hygro, temperature, pressure, battery and user function)
and appropriate measurement units.
To enter the Measurement option:
1. Press
[SEL] from the Operate Mode window until you have
reached the desired measurement.
2. Press
[ENTER] to open the Display Menu.
3. Be sure the Measurement option is highlighted, and press
[ENTER].
The screen appears similar to Figure 5-5 on page 5-8. The left
column displays the five measurement data sources, while the
right column displays appropriate measurement units.
4. Use the [
T] and [S] arrow keys to reach the desired data
source, and press
[SEL].
5. Then use the [
T] or [S] arrow keys to select the desired
measurement unit (or diagnostic parameter). Press
[F3], OK,
to confirm the entry, or
[F2], Cancel, to leave the window
without making any changes.
6. The screen returns to Operate Mode, and displays any
changes.
To Next Page
Loading...
