Displaying and Configuring Data 5-1
August 2003
Chapter 5
Displaying and Configuring Data
The PM880 allows you to view from one to four different
measurement parameters simultaneously. The screen can show
these parameters not only in numeric format, but as line or bar
graphs as well.
You can configure any given measurement for your particular
requirements. To configure an individual measurement, press
[SEL] from the Operate Mode window shown in Figure 2-3 on
page 2-8. A cursor appears next to the parameter closest to the
upper left corner. Continuing to press
[SEL] enables the cursor to
scroll through the other displayed measurements. Once you have
reached a particular window, pressing the
[ENTER] button opens
the menu for that window, as shown in Figure 5-1 below. To
learn how to use the display window menu, go to pages 5-2
to 5-6.
]
Figure 5-1: Display Screen After Pressing [SEL]
2002/11/30 09:53 AM
X
Dew Point, °C
Temperature, °C
-52.0
23.0
Pressure, PSIg
55.00
10.0
Run Time, Hours
ABC
K
K
K
10 Minutes
-30
70
0
612
MeasurementFormat View
About
To Next Page
Loading...
