GE PM880 User Manual (English)

Other manuals for GE PM880

Operations & Installation Guide249 pages

Specifications4 pages

Questions and Answers:

R
richardstrevorAug 2, 2025
What to do if GE PM880 Measuring Instruments screen reads the wettest moisture calibration value?
- M
  Michelle JacobsAug 2, 2025
  If the screen of your GE Measuring Instruments consistently displays the highest moisture calibration value, it could be due to several reasons. The probe might be saturated with liquid water on the sensor surface or across electrical connections, or there could be a short circuit on the sensor. Contamination with conductive particles or an improper cable connection could also be the cause. To resolve this: * Clean the sensor and sensor shield, then reinstall the sensor. * Run 'dry gas' over the sensor surface. If the high reading continues, the probe may be shorted and should be evaluated. * Check the cable connections to both the probe and the PM880.
S
scottcraigAug 18, 2025
What to do if GE PM880 Measuring Instruments screen reads the driest moisture calibration value?
- K
  Kenneth BurtonAug 18, 2025
  If your GE Measuring Instruments screen consistently displays the lowest programmed moisture calibration value, it could be due to an open circuit on the sensor, non-conductive material trapped under the contact arm, or an improper cable connection. To address this issue: * Clean the sensor and the sensor shield, then reinstall it. * Check the cable connections to both the probe and the PM880. * If the low reading persists, the probe should be returned for evaluation.
K
kimestradaAug 25, 2025
How to fix slow response on GE Measuring Instruments?
- V
  Victor TaylorAug 25, 2025
  A slow response in your GE Measuring Instruments can be due to slow outgassing of the system or contamination of the sensor with non-conductive particles. To resolve this: * Replace the system components with stainless steel or electro-polished stainless steel. * Clean the sensor and the sensor shield, then reinstall the sensor.

GE PM880 Specifications

General

Type	Power Meter
Display	LCD
Communication	Ethernet
Measurement Parameters	Voltage, Current, Power, Energy, Power Factor
Power Supply	85 to 265 VAC, 50/60 Hz
Dimensions	96mm x 96mm x Depth (Panel Mount)