Servicing the PM880 8-21
August 2003
Checking Security Levels and Remote Access
Security (cont.)
1. The first prompt asks for the security level. Press [ENTER] to
open the drop-down menu, scroll to the desired level, and
press
[ENTER] to confirm the level.
2. The following three prompts control three separate remote
access security settings: PanaLink remote access to the
PM880, receiving files from a PC via IrDA, and transmitting
files to a PC via IrDA.
a. Scroll to the desired setting.
b. Press
[ENTER] to change the setting: that is, to turn it on
(as indicated by an X in the window) or off.
c. Repeat steps a and b for the other settings, if desired.
Note: The remote access security settings are only available to
operators with Operator or Service level passcodes. The
default setting permits access with all three settings.
• Press [F2] (Cancel) to return to Operate Mode without
changing the current settings.
• Press [F3] (OK) to confirm the changes and return to
Operate Mode.
To Next Page
Loading...
