August 2003
2-16 Initial Setup
Screen (cont).
The middle of the screen shown in Figure 2-7 on page 2-15 is the
work area, which displays the measured parameters, numeric
measurements, and both bar and line graphs. (When you enter a
selection on the Menu Bar discussed in Chapter 3, Programming
Site Data, this area displays menu prompts.) A line at the bottom
of the area also displays error code messages, which are described
in more detail in Chapter 9, Diagnostics and Troubleshooting.
The system tray displays icons that indicate meter operations not
otherwise shown. Table 2-2 below lists the icons and their
meanings.
The bottom of the screen displays the three function key options:
F1, F2 and F3. These keys have different functions, depending on
the task you are performing.
Table 2-2: Icons in the System Tray
Icon Function Meaning
IR Transfer IR data transfer in progress.
Alert Indicates the meter encoun-
tered an error in operation.
Log Indicates a log is pending (no
marks) or running (marks).
Backlight Indicates that backlight has
been activated.
Low Battery
Alert
Indicates 10 minutes or less
of battery run time.
Snapshot
(To file)
Indicates that the Snapshot
function has been activated,
so users can take screen cap-
tures (see page 6-23).
(To Printer)
To Next Page
Loading...
