August 2003
3-12 Programming Site Data
Entering Saturation Constants (cont.)
5. Use the arrow keys to scroll to additional data points, and
repeat steps 3 and 4 until you have entered the values for each
point.
Note: To insert an additional data point, press
[F1] (Insert).
To delete a data point, press
[F2] (Delete).
6. When you have completed entering values, press
[F3] (Exit).
The PM880 returns to the Saturation tab at the top of the
screen.
You now have three choices:
• Use the arrow keys to enter another Calibration window and
program additional data (if available, depending on probe
type).
• To confirm the data and return to Operate Mode, press [F3]
(OK). The PM880 returns to Operate Mode.
• To leave the window without saving the data, press [F2]
(Cancel) or the
[ESC] key. The PM880 returns to Operate
Mode.
To Next Page
Loading...
