August 2003
3-20 Programming Site Data
Entering User Functions (cont.)
d. When you have completed the label, press [F3] (OK) to
confirm the label, or
[F2] (Cancel) to leave the window
without adding the label.
3. The next prompt asks for the Units Symbol.
a. Press
[ENTER] to reopen the text creation window.
b. Repeat the procedure used for the Label (on the previous
page) to create the Units Symbol.
c. When you have completed the label, press
[F3] (OK) to
confirm the symbol, or
[F2] (Cancel) to leave the window
without adding the symbol.
4. The next prompt asks you to select the number of decimal
places.
a. Press
[ENTER] to open the drop-down menu.
b. Scroll to the desired number of decimal places, ranging
from 0 to 4.
c. Press
[ENTER] to confirm the entry.
5. The final prompt asks for the function itself.
a. Press
[ENTER] to open the function creation window,
which appears similar to Figure 3-10 on page 3-21.
b. Use the four arrow keys to scroll to the desired function or
table, and press
[ENTER] to confirm each entry. Use the
numeric keys to enter numeric values. Press
[F1] (Delete)
to remove any mistaken or unwanted symbols or numbers.
Note: Pressing
[SEL] causes the screen to alternate between a
set of symbols and functions and a list of user functions.
Use both screens to create the desired function.
To Next Page
Loading...
