GE Ultrasonic USM Go - Naming the Data Recorder File; File Selection Mode

Chapter 5. Data Recorder Files
128 USM Go Operator’s Manual
5.1 Naming the Data Recorder File
In the SETUP menu, use the joystick ( ) to activate the DR menu (see Figure 16 on page 127). Then, proceed to the appropriate section
below to either create a new file name or select an existing file name.
5.1.1 File Selection Mode
1. Use the joystick ( ) to select the function titled FILENAME in the DR SETUP submenu. Press the center of the joystick once
( ) to activate the function in File Selection mode.
2. Move the joystick up or down ( ) to select the desired file name from the list of SD card files.
3. Press the center of the joystick ( ) to deactivate the function.