USM Go Operator’s Manual 137
A.3 Pulser
Note: All pulser measurements were taken according to EN12668 specifications.
Pulser Mode: Standard: simulated spike
Optional: uni-polar square wave via software control
Pulser Voltage (SQ Mode): 20 V to 300 V, with a 10 V step and tolerance of 10%
Pulser Falling/Rising Time: 10 ns maximum
Pulser Width (SQ Mode): 30 ns to 500 ns, with a 20 ns step and a tolerance of 10%
Pulser Amplitude (Spike Mode): Low: 120 V
High: 300 V
Damping: 50 ohms or 1000 ohms
To Next Page
Loading...
