CHANNELS
1 Auto Channel Search
2 Add/Remove Channels
3 Signal Type: CABLE
4 VCR PLus+ Channel List
5 Cable Box Setup
0 Exit
,
Press 1 to display the AUTO CHANNEL SEARCH menu.
AUTO CHANNEL SEARCH
What type of signal
are you using?
1 Cable TV
2 Antenna
3>Detect Automatically
0 Cancel
4. Select one of the three AUTO CHANNEL SEARCH options.
Choices one and two are self-explanatory. If you choose Detect
Automatically, the VCR automatically detects which signal
system you have attached to your VCR.
AUTO CHANNEL SEARCH
Now scanning channeL 14
Press any key to cancel
The VCR begins scanning for the available channels--this takes
about one to two minutes. The lowest channel is tuned once the
search is complete. Now, pressing CHANNEL up or down should
only select the active channels.
To Change the Signal Type
1. Press MENU to display the VCR MAIN MENU.
2. Press 4 to display the CHANNELS menu.
3. Press 3 to change the Signal Type between CABLE and
ANTENNA.
Detect Automatically
A strong cable or antenna signal in
your area may cause Auto Detect
to mis-detect. If this should
happen, select I or 2 for the
system you have.
II
To Next Page
Loading...
