Auto TV/VCR
This feature controls whether the TVNCR switch changes
automatically to the VCR mode when the VCR is turned on.
Press 3 to switch between ON and OFF.
Select ON if you want the VCR to switch to the VCR
mode when the VCR is turned on or a cassette is
inserted--This only applies if you connect the IN FROM
ANT. and OUT TO TVjacks of your VCR and TV and
watch your VCR on channel 3 or 4 of your TE
Select OFF if you want the VCR to remain in the TV
mode. This is useful if you watch your VCR on the TV's
video input and you don't want your antenna/cable
signal interrupted by the VCR.
Front Panel (VCR Display)
You can change the brightness level of the fluorescent display
panel on the front of the VCR. Press 4 to switch between AUTO,
BRIGHT, and DIM.
• AUTO brightens the display when the VCR is on and dims
the display when the VCR is off.
• BRIGHT keeps the display bright.
• DIM keeps the display at a low brightness level.
18
To Next Page
Loading...
