Things to Know Before
Components
Connecting
Protect Your Components from Power
Surges
Connect all components before plugging any
power cords into the wall outlet.
Always turn off the TV and other components
before you connect or disconnect any cables.
Position Cables Correctly to Avoid Audio
Hum or Interference
Insert all cable plugs firmly into their jacks.
Place the audio/video cables to the sides of the TV's
back panel instead of straight down the middle after
you connect your components.
Try not to coil any twin-lead cables and keep them
away from the audio/video cables as much as
possible.
Make sure all antennas and cables are properly
grounded. Refer to the Safety "tips sheet packed
with your unit.
Protect Your Components from
Overheating
Do not block ventilation holes in any of the
components. Arrange the components so that air
can circulate freely.
Do not stack components.
Allow adequate ventilation when placing your
components in a stand.
Place an amplifier or satellite receiver on the top
shelf of the stand so heated air rising from it will not
flow around other components.
¥
¥
¥
¥
V
7
V
CONNECTIONS
I
51
To Next Page
Loading...
