Playing Back Audio Only
To get stereo sound, connect the AUDIO OUT jacks of the VCR to
the appropriate input on your amplifier or receiver. Do not use
the phono input. Refer to your amplifier or receiver user's guide.
Using Two VCRs for Copying and Editing
Tapes
Use one VCR as the playback VCR and the other as the
recording VCR.
1. Turn on the TV and VCRs.
2. Tune the TV to the VCR viewing channel (either 3, 4, or TV's
video input).
3. If you connected your VCR using the IN FROM ANT. and
OUT TO TV jacks, tune recording VCR to channel 3 or 4--the
one selected on the back of the playback VCR.
If you have connected your VCR using the audio/video jacks,
make sure you select the line input on the recording VCR.
4. Insert the tape you want to copy into the playback VCR.
Insert a blank tape with safety tab in place into the
recording VCR.
5. When you reach the point on the tape or program where you
want to begin copying, press PLAY.PAUSE and then
PLAY.PAUSE again on the playback VCR. You may need to
adjust the tracking.
6. Press the RECORD button, then press PLAY-PAUSE, on the
recording VCR.
7. Press the PAUSE buttons on both VCRs at the same time to
begin copying the tape.
8. To edit segments that you do not want to copy:
• Press PLAY-PAUSE on recording VCR to pause copying.
• Locate the next segment you want to copy on playback VCR
by using FWD, REV, and PLAY.PAUSE, and then press
PAUSE.
• Press PAUSE on both VCRs at the same time to resume
copying.
9. Press STOP on both VCRs when you are finished.
Caution:
The unauthorized recording of
television programs or other
materials may infringe the rights
of others,
F •
Two VCR Connection
CABLE, CABLE BOX, OR_ANTENNA
PLAYBACK VCR
RECORDING VCR
32
To Next Page
Loading...
