Operating
Operating spreader options
2018-9015-001
09-2016
102 / 192
7.9 Operating spreader options
7.9.1 Self-loading
Warning!
ROTATING DRIVELINE! KEEP AWAY!
Note!
Before loading the spreader, make sure that manure is homogenized
and that the consistency is adequate for spreading. Refer to sections
Technical data - Performance data and Appendix - Consistency test.
● Apply the tractor parking brake and turn off the engine;
● Remove suction hose and pipe from supports located on each side of the
spreader;
● Assemble the hoses and pipes together;
● Close the gate valve (1) by pushing
the gate valve lever (2) downward;
● Open the ball valve (3);
● Unlock the latch mechanism by
flipping the locking flat bar (4);
3
4
1
2
● Insert the suction hose adapter (5) in
the U-shape support (6);
● Pull the receptacle lever (7) to
connect the hose adapter (5) to the
receptacle (8);
● Make sure the O-ring (9) properly
seals the connection;
7
8
6
5
9
● Assemble the suction hose support
supplied with the self-loading
option;
● Install the suction hose support
(10) two meters away from the
spreader;
● Set the height of the support (10)
so that the end of the hose (11)
lays horizontally;
● Make sure the other end of the
hose is well inserted in manure;
10
11
To Next Page