Decommissioning
Temporary decommissioning
2018-9015-001
09-2016
151 / 192
10.3 Temporary decommissioning
Cleaning
Warning!
Beware of potential falls: always walk on the nonslip band installed on
the product.
Attention!
Use cold water to clean this product. Do not exceed 2000 psi [105 bar]
when using a pressure washer and keep the nozzle at a distance of
1 ft [30 cm] from the surface to clean.
● Make sure the spreader is empty;
● Make sure all drains and cleaning openings are closed;
● Fill 1/3 of the spreader tank with water;
● Move the tractor back and forth to stir water inside the tank;
● Move it to a spreading area and spread the wasted water to clean the
discharge pipe and hoses;
● Pressure wash the entire product
and equipment;
● Move to a storage area;
● Open the drains and cleaning openings. Keep them open to allow
ventilation.
Lubricate
● Grease parts labelled with:
● Spray the entire product with a thin
layer of biodegradable oil to protect
from corrosion.
Refer to section Appendix - Label position.
To Next Page
Loading...