Operating
Connecting the spreader
2018-9015-001
09-2016
85 / 192
7.4 Connecting the spreader
7.4.1 Hitching the spreader
Attention!
Connect the hydraulic hoses properly to ensure safe operation. Refer
to section Appendix - Hydraulic diagram.
Note!
The tractor draw bar must be adjusted to minimum length.
Note!
The spreader must be towed by the tractor for which it was designed.
If changing tractor, refer to Technical data - Performance data -
Spreader draw bar inclination section.
● Using the jack (1), position the
spreader draw bar to connect the
tractor;
● When the spreader is connected,
the jack must be placed on the
transport support (2);
2
1
● If a hydraulic jack (3) is used,
connect the hydraulic hoses to the
tractor and adjust the spreader draw
bar height.
3
To Next Page
Loading...