Initial commissioning
Power steering
2018-9015-001
09-2016
80 / 192
6.3 Power steering
Control valve
Attention!
Since tractors can be equipped with an open or a closed hydraulic
system, the control valve must be set with the appropriate plug to avoid
overheating/damaging hydraulic components. Contact your tractor
dealer.
Use the appropriate plug in order to
match the tractor hydraulic system:
● The standard plug (1) is required for
tractor equipped with an open
hydraulic system.
● The beyond plug (2) is required for
tractor equipped with a closed
hydraulic system also called load
sensing in some cases.
2
1
Note!
A new equipment always comes with two plugs, a standard plug
installed on the valve and a beyond plug supplied separately. Make
sure to install the appropriate plug.
Plug change
Attention!
Oil leak will occur when changing the plug.
● Apply Teflon tape on the threads of the beyond plug (2). Do not apply Teflon
tape on the tip of the plug.
● Unscrew the standard plug (1) and replace immediately by the beyond plug (2).
To Next Page
Loading...