Maintenance
Adjust power steering
2018-9015-001
09-2016
146 / 192
Guiding mechanism adjustment
● Remove the bungee cord to lower
the guiding mechanism (1) on the
tractor draw bar (3);
● Grease the pin (2) using grade 2
PRECISION
TM
XL5 MOLY EP2
grease (or equivalent);
● Insert the pin (2) through the tractor
draw bar (3) and the spreader hitch
(4);
● Secure the assembly with a cotter
pin (5);
● Pull the spreader in a straight line
until all wheels are perfectly aligned.
Refer to the Wheels alignment
section below;
● Turn off the tractor and apply the
hand brake;
● Loosen the square head bolts (7);
5
3
4
1/16” [2 mm]
1
7
6
2
● Set a gap of 1/16” [2 mm] between each finger (6) and the draw bar;
● Secure the fingers (6) by tightening the square head bolts (7).
Wheels alignment
● Align the spreader and the tractor by
slowly pulling the spreader in a
straight line;
● Keep them aligned and park them on
a flat surface;
● Check the alignment by measuring
on each side of the guiding
mechanism as illustrated;
● Both measures must be identical, if
not, repeat all steps.
To Next Page