Operating
Spreading
2018-9015-001
09-2016
98 / 192
7.8.3 Spreading with three deflector 38 FT tool bar
Danger!
Before moving the spreader on public roads, make sure the tool bar
is correctly positioned for safe transportation (set to the smallest
position in width, completely raised and locked with safety chains), if
applicable.
Note!
Make sure all local rules and regulations are followed.
Note!
The spreading pattern can be adjusted by changing the deflector
restriction plates and/or by changing the tool bar restriction plate.
● Once on the field, unfold the tool bar arms using the tractor hydraulic control.
Make sure it is placed in spreading position;
● Engage the impeller to start spreading;
● Adjust the tractor speed according to the desired spreading rate. Refer to
section Appendix - Spreading rate calculation;
● Disengage the impeller when the spreader is empty;
● Fold the tool bar arms using the tractor hydraulic control.
To Next Page
Loading...