GEA VP8002 - Installing the Control Unit and Power Supply

assembly and installation
Installing the control unit and power supply unit
7160-9001-560
01. December 2020
17 / 74
Local purchased items
● Network switch (if more than one VPU)
5.6 Installing the control unit and power supply unit
Installation variants
The control unit can be installed in the following ways:
● In the housing(with an internal power
supply)
- Wall installation
- Installation of the frame
VP8002
SV
● In the housing(with an external power
supply)
- Installation of the frame
Example:
- Per place identification (AR PerFormer)
VP8002
SV
● In the control cabinet (pre-assembled, with an external power supply)
Example:
Per place identification (DairyProQ)
Installation instructions
● For installation variants not described, please refer to the corresponding
instructions for the connected system.
● In the milking parlour, the unit must be installed in a housing with IP65
protection!
● Install network cables at sufficient distances to live cables.