GEA VP8002 - Settings in the User Interface (VP8002)

Commissioning
Basics of commissioning
7160-9001-560
01. December 2020
31 / 74
6.3.2 Settings in the user interface (VP8002)
Notes
● This section only contains examples for settings
(not a complete description of the menu).
● The user interface language can be set.
The illustrations in this manual are for guidance only and are not in the
language of the country.
● The Web browser must support HTML5!
● The user interface menu depends on the version and may differ from the
menus shown.
IP address for access via user interface
Licences control units are preconfigured as follows:
● IP address for LAN1: 192.168.1.100
If the control unit and computer are in different networks, the IP address must
be set manually.
See section: Settings in the Device menu (VP8002)
Part No. Description System (licence for)
7160-9067-300
Control unit VP8002
(with basic licence)
Milking parlour walk-through
identification
7160-9067-310
Control unit VP8002
(with basic and individual
licence)
CowScout
7160-9067-320 AutoSelect
7160-9067-330 Parlor ID Solutions (DR T8900 / PPID)
7160-9067-340
GEA AMS (Monobox, DairyProQ,
DairyRobot R9500)
● Automatic address assignment is switched off (DHCP=Off)
If automatic address assignment is switched on, the control unit automatically
obtains an IP address after connection to a DHCP server (e.g. router).
Show the device's IP address in the menu
The IP address is needed for accessing the user interface.
1. Call up menu item
IP
Network settings (Ethernet)
di
Show IP address (Show IP address)
2. Press key (briefly)
- IP address appears
Example:
IP 192_168_1_100
("." appears as "_")
3. Note the IP address